In a message dated 99-02-27 19:32:12 EST, you write:
<< I put my headers on when the truck was only a couple of months old and I
still had to use a lot of liquid wrench/penetrating lubricant. So, I'd
spray the hell out of yours and let it sit for awhile before I tried
anything... I'm talking spray it, wait 5 minutes, spray it again, wait
another 5 minutes and repeat 'till your satisfied you can't possibly get
anymore in there (or your can is empty) then wait 30 minutes to let it
really sink in! >>
Tom,
I was just thinking about another area that might help me out with the
extraction of the bolt/stud; what do you think about it: Would it be better to
do it when the engine is completely cold; like in the morning? or Would it be
better to let the engine warm up and try to get the bolt/stud out when the
engine is warm? I do have mechanic's gloves, so the temp of the manifolds wont
'really' be a concern. I was just curious of what would be better/easier if
the block/manifolds were warm or cold; this could possibly help me out a
little more, you think?
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:04 EDT