Re: Re: Six Grease Fittings on a 4x4?!

From: mrdancer (mrdancer@camalott.com)
Date: Mon Apr 05 1999 - 08:04:28 EDT


hmmm, 3 pumps always works for me. I've just always heard that pumping 'til
grease comes out is bad (farm experience). Anyone else have any ideas on
this??

'92 Dak CC 2wd 318 3.55
'84 GoldWing Interstate
----- Original Message -----
From: <fawcett@uism.bu.edu>
To: <dakota-truck@buffnet.net>
Sent: Sunday, April 04, 1999 11:46 PM
Subject: Re: DML: Re: Six Grease Fittings on a 4x4?!

> Holy Cow! Three good pumps?! If I give 1/2 a pump to each, of what I'm
> calling the upper and lower ball joints, it's pouring out the sides! I
> always thought this was like overpressure (like in a modern tank), that
> wouldn't cause any harm and would prevent any grit or water from finding
> it's way into the joint? Darn (still Easter), I hope I'm not doing any
> harm!
>
> Tom
> ______________________________ Reply Separator
_________________________________
> Subject: DML: Re: Six Grease Fittings on a 4x4?!
> Author: <dakota-truck@buffnet.net> at smtpout
> Date: 4/4/99 9:39 PM
>
>
>
> Look for anywhere there's moving parts / joints. Also, it's not a good
idea
> to squirt grease until you see it come out - that's a good way to ruin the
> seal. It's best just to give 3 good pumps from the gun to each zerk. Do
> that at every oil change or every 3k miles and you'll be ahead of probably
> over 90% of the people with regards to maintenance.
>
> '92 Dak CC 2wd 318 3.55
> '84 GoldWing Interstate
>
> ----- Original Message -----
>
> From: <fawcett@uism.bu.edu>
> > Gosh darnit (Easter speak)!
> >
> > I changed the oil this morning before heading out to my folks and found
5
> > zirk fittings to grease while I was at it:
> >
> > 1 ea. side, upper ball joint.
> > 1 ea. side, lower ball joint.
> > 1 on front output shaft (front drive shaft)
> >
> > Where the heck is the other one (somebody said there were six)! I
banged
> > my head and almost swallowed the flashlight I had in my mouth lookin'
for
> > the sixth one!
> >
> > On another note, how do you know when you put enough grease in the front
> > output shaft? All the others have rubber boots that the grease starts
to
> > seep out of when their full.
> >
> > Thanks!
> > Tom
> >
> > P.S. Hope all had a wonderful Easter celebration!
>
>



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:39 EDT