Hi Steven -
That connector is easy to unclamp. Insert the blade of a pocket knife in
the slot just below the coil wire. Gently twist the knife edge upward to
pry open the clip. It should take very little effort.
Good luck-
Dave
----------
> From: SmokinDakota <smokindakota@email.msn.com>
> To: Dakota Mailing List <dakota-truck@buffnet.net>
> Subject: DML: Installed M.P. Wires, BUT. . .
> Date: Sunday, April 04, 1999 9:47 PM
>
> Well, I finally got around to installing the Mopar Performance Wires.
They
> look nice. I ran into one problem. The wire that goes to the coil(i think
> its the coil, close the fan) is connected by a whatchamacallit(you know,
the
> thing that keeps the wires neat and organized). All the other wires
> connected to the whatchamacallit easily, but this wire connected to the
coil
> is attached to one of the whatchamacallit's and is locked in there. In
other
> words, It doesn't just snap into place like the others. How do I unclamp
the
> wire from this whatchmacallit? I hope I didn't confuse everyone with my
> technical jargon :)
>
> Thanks,
>
> Steven 2me
> http://www.smokindakota.com
> AOL Instant Message = SmknDakTrk
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:39 EDT