What year is your Dak...the '97's use a .045" Factory Gap...??
----- Original Message -----
From: Patrick Delgado <dadoctah@worldnet.att.net>
To: <dakota-truck@buffnet.net>
Sent: Sunday, April 18, 1999 11:12 AM
Subject: Re: DML: Attn: MSD users
> Jason,
> I just installed my SS coil today. I screwed it into the fender liner just
a
> couple of inches away from the stock location. I used 1.5" X 8/32 sheet
metal
> screws to hold it in place. I cut the wires about 2" away from the
connector
> that goes to the bottom of the stock coil and crimped on the terminals
> included with the coil. The existing coil wire needed to have the rubber
boot
> trimmed about 3/8" to go over the "post" of the coil. I had a couple of
> friends "helping" so it took about 4 hours to do the coil and regap the
plugs
> ot .045". If I'd done it alone, maybe 1 hour, tops, for coil and plugs.
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:48 EDT