On Thu, 29 Apr 1999 22:58:32 -0400 (EDT), you wrote:
>
>Date: Thu, 29 Apr 1999 22:25:37 -0400
>From: Mike Williams <williams@kode.net>
>Subject: DML: MP open element air cleaner (report of problems)
>
>Warning to anyone considering buying this air cleaner.
>
> *** snip ***
Mike,
I'm runnng this setup and don't have a large gap in mine - The K&N
element may be 1/4" smaller than the base/lid, causing (maybe) a 1/8"
gap at any given point in the circumference.
>
>Other problems with the MP cleaner it didn't have a fitting for the air
>breather, The base is heavy duty and was a bear to bend. You have to
>bend the base so the front of it almost touches the A/C bracket to get
>hood clearance.
>
I used a chassis punch to make the hole and a 90 degree stainless
compression fitting 1/2" male pipe (in air cleaner base) with a 1/2"
electrical conduit locknut to 1/2" tubing (short stub for breather
hose). The hose slip fits kinda loose, so I used a clamp (hidden). I
do remember "leaning" on the front of the base to angle it down a
little, but it still rubbed my liner until I used a grinder on the front
ribs to round off the sharp edges.
>- --
Good luck,
Russ Selkirk
-- '96 Black Impala SS '85 Silver Monte SS '98 Amethyst Dakota RC R/T - Port Neches,Texas ================================= NOTE: Anti-Spam Address! Please reply to: RAS002@worldnet.att.net =================================
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:56 EDT