My friend and I installed it. It took about 6 hours. We will probably rip it apart again this weekend to install the new rear servo, so it will shift even harder 1-2. My advice is to watch the video first, as the instructions are not drawn using a 46RE trans. The first page had us lost, until we watched the video, and then everything was smooth sailing from there out. Right now it seems to shift harder 2-3 than the 1-2, but it is definitely an improvement, except for hitting the rev limiter.
Chris Tesinsky
'99 Solar Yellow R/T CC
----- Original Message -----
From: Jason&Sarah
To: dakota-truck@buffnet.net
Sent: Sunday, May 02, 1999 8:58 AM
Subject: DML: Re: Installed TransGo shift kit, now hitting rev limiter 1-2
How was the install? Did you do it yourself? Any advice?
Jason
I installed my Transgo shift kit today, and now if I stand on it, it bounces of the rev limiter in first gear. I think some others have had this problem. What did you do to cure this problem?
Chris Tesinsky
'99 Solar Yellow CC R/T
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:56 EDT