Reset the computer.
----- Original Message -----
From: Ryan LeBlanc <rleblanc1@earthlink.net>
To: Dakota-Truck@Buffnet. Net <dakota-truck@buffnet.net>
Sent: Thursday, May 06, 1999 2:20 AM
Subject: DML: Check Engine Light after Throttle Body Work
> Well, I decided to Port and Polish my Throttle Body today. In the middle
of
> the project, I needed to put the windows up in the truck, this made me
turn
> the key to the on position. I had a check engine light stay on, but
didn't
> worry, as the whole throttle body was out of the engine. After the job
was
> done, and all back in, I started it up, only to see the check engine light
> still on. I let it warm up, ran it around the block, light still on.
> Decided to let it sit over night and ask you guys if you had any ideas,
well
> see what is happenin' in the morning. Will the key cycle that shows the
> error code clear this? What is the key cycle again? How many on's and
> off's? Thanks,
>
> Ryan
> 97, CC, 5.2L, ...
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:58 EDT