Thanks Rich,
Yea, I need to call him back. (One of the incorrect sets I received came
from Jeff.) I'm going to ask for another gasket set. The ones he sent were
stamped with the name "DURABLA". These are twice as thick as the Mr.
Gaskets. It's just two bad they were for the pre-magnum engine.
Rich - VA
-----Original Message-----
From: Richard A Pyburn [mailto:rap777@juno.com]
Sent: Thursday, May 06, 1999 2:03 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: V8 Magnum Header Gaskets - HELP!
Rich
I've got the gaskets that came with the JBA headers from the factory (Mr.
Gasket, I think). sorry I don't know the part number but why not e-mail
Jeff at JBA. I'm sure he'd help. The address is jtowers@jbaheaders.com
I have had no leaks whatsoever. No bolts backing out either.
Richard in SA
On Thu, 06 May 1999 11:16:54 -0400 "Wisotzkey, Rich"
<Rich.Wisotzkey@gsc.gte.com> writes:
>If you are using headers on your engine, would you please reply back
>with
>the manufacturer and model number of the gaskets you are using? Also
>let me
>know if you have had any sealing problems, and if so, what you did to
>correct it. I have ordered three sets from three different places,
>and all
>three have come in for a pre-magnum engine even after I specified "for
>a
>magnum 318". My original set of gaskets are shot, and leak like a
>strainer.
>Thanks!
>Rich - Ashburn, VA
>
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:58 EDT