Each corner has a clip, just pry it with a hard plastic spatula(so you don't
mark it up) at the corners.
-----Original Message-----
From: owner-dakota-truck@buffnet4.buffnet.net
[mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of Densteadt,
James
Sent: Tuesday, May 18, 1999 9:30 AM
To: dakota-truck@buffnet.net
Subject: RE: DML: you stereo gods!!
Anybody have any clue as to how to get the dash plate off with out breaking
it in half? Seems like it's gonna snap in two, or maybe I'm just afraid to
pull it off with that much force! OR....would it be easier to just find the
wires down near the floor leading to the amp and tap into it there?
-----Original Message-----
From: Michael Guzinski [mailto:m.gski@CWIX.com]
Sent: Tuesday, May 18, 1999 11:10 AM
To: dakota-truck@buffnet.net
Subject: RE: DML: you stereo gods!!
I would run the remote from the lead that comes from your stereo to the
factory amp(in the dash behind the radio). Just use one of those clip on
wire tap conectors(3m and Autotek make them)(bet you can find them at an
auto parts store,Radio Shack or even Wal-Mart), clamp it down, put a 1amp
fuse in line and run it to your amp.
>So are you meaning the dash to be the radio...run the remote from the
radio?
>Or should I tap into the wire running to the stock amp in the kick panel?
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:06 EDT