RE: Poor Man's K&N Gen II (oops--a little long)

From: Michael Guzinski (m.gski@CWIX.com)
Date: Mon May 24 1999 - 17:17:12 EDT

Next message: Jason Yates: "Po'boy's Intake Pictures"
Previous message: Jason Yates: "Re: Poor Man's K&N Gen II (oops--a little long)"
In reply to: Jason Yates: "Re: Poor Man's K&N Gen II (oops--a little long)"
Next in thread: Jason Yates: "RE: Poor Man's K&N Gen II (oops--a little long)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

What is the inside diameter of the factory air hat? I have access to a 2.5"
and 3" (ID) galvanized steel pipe, already has the mandrel bend in it.

Mike Guzinski
m.gski@CWIX.com

Next message: Jason Yates: "Po'boy's Intake Pictures"
Previous message: Jason Yates: "Re: Poor Man's K&N Gen II (oops--a little long)"
In reply to: Jason Yates: "Re: Poor Man's K&N Gen II (oops--a little long)"
Next in thread: Jason Yates: "RE: Poor Man's K&N Gen II (oops--a little long)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:09 EDT