In a message dated 5/27/99 7:33:15 AM Eastern Daylight Time,
k85go76@erols.com writes:
<< It is
a technically doable deal to put one in a Dak R/T but other than floor hole
cutting and all don't ask me whether there would be a problem in the SBEC
(which also regulates the auto trans). There may be no issue with the
computer at all (just an unused circuit?). >>
As far as the computer would go, you would just have to use a manual tranny
comp.. The floor hole isn't a problem either since there is a patch layout
on the sheet metal under your carpeting that will locate exactly where the
hole should be.
Eric
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:10 EDT