Re: Timing: Initial vs total advance? Was: Can anyone help with my stalling problem?

From: Bernd D. Ratsch (bernd@texas.net)
Date: Mon Jun 14 1999 - 18:59:06 EDT

Next message: Alan Short: "Re: 1999 Dakota Service Manual For Sale"
Previous message: Jon Steiger: "Stickers and Donations Was: LEACH HEADERS!!!!!!!!!!!!"
In reply to: Jon Steiger: "Timing: Initial vs total advance? Was: Can anyone help with my stalling problem?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hey Jon,

Initial Advance: The base/idle setting...i.e.: 10 degrees BTDC (Before Top
Dead Center) @ 800rpm

Total Advance: The total of your base, vacuum (if applicable), centrifugal
(if applicable), and/or pre-programmed (computer) timing. (Normally this is
anywhere from 32 - 40 degrees BTDC @ 3000-3500rpm

> Ok, I'll ask. :-) What's the difference between initial and total
> advance?
>

Bernd D. Ratsch
Pflugerville, TX
'97 Dakota SLT/CC (V6)
bernd@texas.net
http://lonestar.texas.net/~bernd/Dakota.htm
ICQ#: 39320084

Next message: Alan Short: "Re: 1999 Dakota Service Manual For Sale"
Previous message: Jon Steiger: "Stickers and Donations Was: LEACH HEADERS!!!!!!!!!!!!"
In reply to: Jon Steiger: "Timing: Initial vs total advance? Was: Can anyone help with my stalling problem?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:24 EDT