Okay, after only a month, I have FINALLY replaced that leaking tailshaft
seal on the R/T. It has been in the garage since the seal went out after
a 110+ MPH pass to work by my wife. The new seal is P/N 05431216, by the
way. It looks like the old seal just lost the inner and outer lips (they
were burned off and hanging on in places) (no jokes now!). I will grease
the heck out of the new one when the driveshaft goes on.
Anyway, my question: for those of you who have balanced their
driveshafts, where did you get it done? The biggest driveshaft shop in
Houston cannot do aluminum (I am assuming the Alcoa name on it means it
is aluminum). Has anyone successfully gotten their R/T driveshaft
balanced? Thanks.
Gene Beaird
98 Flame Red CC R/T
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:26 EDT