9" cone with 3" id. Used tie wraps to hold it in place and no PVC. Used a
heat resistant polymer.
-----Original Message-----
From: Dester243@aol.com [mailto:Dester243@aol.com]
Sent: Saturday, June 19, 1999 3:14 AM
To: dakota-truck@buffnet.net
Subject: DML: What conical K&N filter?
Hey to all the folks who made their PVC piping intake. what cone K&N filter
did you use? how big? what's the diameter of the opening and what's the
diameter of the opening on the hat? also, some people say they modified the
hat by taking the spider out? how did you do that?
Final question. how did you put support brackets in? or did u just leave it
to the hat to hold it up?
-Dester
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:27 EDT