Chad,
Yes, they would still bolt up. The problem is the clearance between the
engine and the frame. If the headers were designed for x amount of
clearance and suddenly it wasn't there anymore, you get an interference
problem. I can't say anything about the EGR, I'm not familiar with that
one. I'll try looking it up in my manual and get back to you. (My '96 does
not have an EGR valve, but I use a '95 manual.)
Rich - Ashburn, VA
-----Original Message-----
From: Chad [mailto:mcc@negia.net]
Sent: Tuesday, June 22, 1999 10:41 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: RE: 95,6,7 headers
What about the EGR? Why would it matter even if they did move the
engine? Would they still not bolt up? Is it something that I can modify
to work?
Thanks,
Chad
Rekker21@aol.com wrote:
>
> In a message dated 6/22/99 8:54:21 AM Eastern Daylight Time,
> Rich.Wisotzkey@gsc.gte.com writes:
>
> << I understand they moved the engine. I can't remember which way, but
they
> moved it either left or right about one to one and a half inches. >>
> Hm, never heard that before. I thought it was because of the EGR.
> Eric
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:28 EDT