Doc,
Theoretically you could just slide it back, but you might as well just
do the whole job and replace that clutch!
Eric
mh wrote:
>
> Hi,
> The throwout bearing in my '94 Dak is going out. Can I just slide the
> transmission back or do I need to set it on the ground? Is there any
> particular way I need to take the drive shaft loose? Guess I might as well
> change the clutch while I'm at it.
> Any other tips and/or advice would be welcome.
> Thanks,
>
> Doc
> '94 SLT V8
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:48 EDT