Greg,
try this stuff called "PB Blaster" our Wal-Marts
just started to carry it down here; previously only
found at a few parts stores.. great stuff, best
penetrant oil I've used. I also use it for noisy
bushings, etc..
--- NVMYDakota@aol.com wrote:
> I just got some Monroe Sensatraks, great shocks,
> but the rears where
> a bitch. Thed expand before I could cram em in,
> also the exhaust pipe got in
> the way, had to remove end section, install shock,
> reinstall end section, no
> rubbing when in, but couldn't angle them in with the
> pipe there? Am I the
> only one with this problem.
> Then theres the front shocks, finally got the nut
> off the pass side,
> but the drivers side is so rusted on there I don't
> what to do? any
> sugjestions (yes I do have the removal tool)
> Greg
>
===
Jon Smith -- Raleigh, NC
'95 CC SLT 4x4 318 auto (15.653@89.12)
MP comp, JBA headers, 8.5mm MSD wires, 14x3 FABM & SBBS, dual cat-back glasspacks, 180 degree thermo, spectre wire dividers, ASP underdrive crank pulley, Hayden 16" elec. fan
http://come.to/killbilly
ICQ # 9720504
IM: Fast4x4
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:56 EDT