I have the NRAuto white face gauges on my truck. They
weren't hard to put on at all. Just need to remember
the needle positions and such. Just take off the dash
and get to the old gauges. Then take the stops off
them and peel off the old gauges. Stick the old stops
onto the new face, then stick it to the gauge backing.
Make sure you get an idea of where the needles are at
when engine is warm. Also, keep it in first gear and
kick the rpms up to 1000 and see what your speed is.
Then when you get the new gauges on, keep the gauge
cover and dash off and drive at 1000rpms and adjust
your speedo to that. Don't put the needles on fully,
so you are able to pull them off and adjust them
easily, while driving. Either than that, nothign to
it. Good luck. If anymore questions, email me
privately.
===
Later,
Geoffrey
~~98 DAK CC SLT 3.9L V6 Metallic Red~~
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:10 EDT