It's a 1/4" Pipe Plug (Pipe Thread is coarse) and they're no longer that
1/2" with a square hole (or head) on them. If that doesn't fit, try a 3/8"
plug.
-----Original Message-----
From: owner-dakota-truck@buffnet4.buffnet.net
[mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of
Dester223@aol.com
Sent: Tuesday, August 10, 1999 6:49 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: IAT Sensor relocated with success!!
Bernd. You said 1/4 of an inch bolt with coarse thread? Wow. That doesn't
fit and i bet it'll just fall straight thru. I'm using a 1/2 of an inch
bolt
on it right now and can barely get 1/8 of the bolt in the lil hole. WHAT am
i buying wrong? the 14mm bolt was too big. but it had the correct thread.
The 1/2 bolt fits, but with the wrong thread. ?!?!?!
-Dester
<< Probably not anything substantial (I don't worry about too much anyway)
but
I will be posting some updates after the first week of driving with the
relocated sensor.
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:44 EDT