I don't quite follow. Could you explain further?
Dr. Pat
----------
>>
>>> I think the idea is to just weld an additional heat sheld to the bathtub
>>> gasket (the one that covers the lifter valley)... But I've heard of a
> good
>>> alternative to this is that after you've made the mods to the intake,
> then
>>> have the bottom of the intake sealed up with 1/4" plate Aluminum... it
> will
>>> act as a heat sheild, and prevent the vacuum leak problem in the future..
> as
>>> well
>>>
>> as further reducing the plenum volume.
>>
>>> Gary Shook
>>>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:04 EDT