At 03:44 PM 9/18/1999 -0400, you wrote:
>Anybody using the vertical Made for You (not your engine) wire looms?
>If so, did you a: remove the existing threaded studs and use the
>hardware supplied.
> b: cut a groove in the nylon holders to
>accommodate the lip on
> the valve covers or use spacers.
>
>Thanks
>
>John
>
>
>
I have those. I just had to buy longer hex bolts to put them on. What
valve covers do you have? I have the Mopar Performance valve covers, they
are thicker in the flange area than the stock ones.....
Brian
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:55 EDT