Or if it is a 4x4, the gear is in the transfer case.
Randy
-----Original Message-----
From: Jetmugg@aol.com [mailto:Jetmugg@aol.com]
Sent: Friday, October 08, 1999 8:43 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: Rear end Gear Swap Question
Not sure about the later model trucks, but the '92 to '96 do not use any
computer controls for the speedo. The speedo pinion gear is located on the
side of the transmission housing, at the point where the cable enters the
tranny. This pinion gear would need to be changed (less than $10 part) to
keep your speedo reading correctly.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:17:45 EDT