thanks for the advice, i will check it all out today... and i don't mind
all the messages, so keep posting!!
mike k
>From: SS454454@aol.com
>Reply-To: dakota-truck@buffnet.net
>To: dakota-truck@buffnet.net
>Subject: Re: DML: front end vibration
>Date: Sun, 7 Nov 1999 03:08:48 EST
>
>ball joint or wheel out of balance. also could be a bent rim or bearings
>getting bad.
>Rob
>Jack up the truck and try to wiggle the tire by grabbing it from the top
>and
>bottom if it wiggles bad bearings or ball joint. Look at the spindle and
>see
>if the ball joint is moving at all. Than get a LARGE flat head screwdriver
>and insert it between the a arm and the spindle. Try to pry up . if there
>is
>movement the ball joints are shot and need to be replaced. Sometimes shocks
>blow seals too so it could be that too. Also check the rubber bushings if
>they get bad the a arms could be wobbling around and causing that. I know
>im
>telling you a lot but go slow and check off stuff as good or ok obad. this
>way youll come to the bad part(s) if you need any help you can e mail me
>directly SS454454@aol.com
>Rob
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:08 EDT