I had 24# injectzors in it to start with and ran fine, I replaced them with
a new set and it would not run, I switched back to 19# and it runs fine.
Mark Kuzia
95 Dak 5.9L, 5-spd, 4.10-SG
13.790 @ 99.42 mph (2.091 60 ft)
99 Dak 5.2L, 5-spd, 3.92-SG
14.896 @ 91.08 mph (2.072 60 ft)
flyboy01@worldnet.att.net
http://home.att.net/~flyboy01/360Dakota.html
----- Original Message -----
From: <TommFern@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Sunday, November 14, 1999 7:53 PM
Subject: Re: DML: HELP! I Installed my new 24# injectors today, now my
truckstart!
| Hmmm, I have swapped back and forth 24lbs(ford svo)inj more times then I
can
| remember. I now currently run 30lbs. No problems. Mine is a 92. My buddy
runs
| 24s on his 94 with no regulator. I'm kinda at a loss. Could you have
perhaps
| missed connecting something up? A couple of the injs could be bad, but
that's
| a long shot. check your codes with the 24s in and recheck your fuses. I
would
| have a hard time believing that the computer is not tolerating the change,
| since so many have done this swap without problems. Keep us informed of
your
| progress. Sorry I can't give you anything definitive.
| Tom
|
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:11 EDT