In a message dated 12/12/99 2:22:10 PM Eastern Standard Time, bernd@texas.net
writes:
>
> Austin,
>
> I just ran a few simulations on the old Dyno program and found that from 8
-
> 10psi boost...the HP/TQ gains at higher RPM (for the Dodge Magnum V6) were
> nominal. HOWEVER, detonation was much more likely without a better fuel
> delivery system. The 19lbs injectors will only run up to about 240hp max.
> Anything beyond that and I had to change the injector rates on the program.
> I've run similar tests on my engine configuration which was almost "Dead
> Nuts" with the actual Dyno runs I did several months ago.
>
This is very good information, thank you. Do you suggest adding 24#
injectors?? Like I said before I bought the SC off of Nick, and he told me he
was running 10# at six grand. I'm not getting up that high so he told me that
i'm running around 8 pounds. I don't have anything yet, but along with the
MSD 6 i ordered a boost gauge and a air/fuel ratio gauge. This way I'll know
exactly what's going on in there. To be perfectly honest I don't believe I'm
running 8 lbs, but no way to be sure until I put the gauge in.
-Austin
SuperVipertruck
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:52 EST