hhmmm.... you raise a good point... may be easie to just give someone a large chunk of change and tell em' to take care of it for me ;-)
thanks for the advice dude!!
-mike d.
88 6er with Slush-o-matic and 3.55 one-legged rear,
lowered, modded, and painted =)
http://members.xoom.com/dakotaperf/index.html
>>> <Shaun.Hendricks@bergenbrunswig.com> 12/09/99 07:23PM >>>
I'm here and I'm far from a guru. Having owned a very cantankerous
turbocharged car just makes you understand the ins & outs of these beasts.
Rather than try to "Adapt" heads or some other header to do it, I'd just bite
the bullet and pay for custom headers to be built specifically for the units
you are trying to use. I think you'll find a turbo manufacturer willing to
point you to someone who can help. This way the manufacturer can give all the
specs to the pipe benders so that everything comes out perfect.
Now, I'm not sure I'd go with a twin turbo setup on a 6er. Your gains in
pressure would be minimal as compared to a large Varible Geometry turbo. The
VG Turbos also simplify the installation since they don't need wastegates.
They have a simple pressure relief valve on them, not a wastgate. I'd rather
have the force of a single large turbo than mess with the balancing headaches
of twin turbos. The small twin turbo setup would be to eliminate turbo-lag,
but that's what the Variable Geometry does on the larger Turbos.
I'd talk to Allied-Signal (Garrett) and see what they have to say if someone
is serious about turbo-charging their dak. Banks is another good turbo, but I
don't think they have a Variable Geometry unit.
Shaun H.
---original message---
that's easy for you to say =) I could figure out how to do it, but I don't
have the tools or know-how to actually pull it off.
I'm wondering if a manifold or header from a Syclone or something could be
adapted? Far stretch, but maybe do-able. I don't really know that much about
turbos.... I know SOME, but not enough to fab up a twin-turbo set-up for my
dak. Besides, it may just
be easier to fab up a SC set-up to go on the premag.... this is gonna' be an
expensive one, but to see the look on a 'stangs face when a premag 6er runs a
12 would be priceless =)
Shaun Hendricks is one of our in-house DML turbo gurus. Hey Shaun, you out
there?!
- -mike d.
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:55 EST