Bernd D. Ratsch wrote:
>
> It may work...but that's asking for it on a stock motor. On my old Camaro,
> we ran (safely) a 250HP shot. Granted, she had a Steel Crank, Forged Rods
> and Forged 10:1 Pistons, and a thicker ring-land on the rings helps out
> quite a bit. Took it off because that was one of the causes for the
> transmission and rear-end to blow. (Oops)
>
> Dan Dean runs a 200 shot on his 5.9....
> Alan S.
My old Camaro again,
Just an opinion here, but an old Camaro isn't a new Dodge...no
comparison.
FYI, the limiting factor in the equation is fuel pressure.
If you can maintain constant fuel delivery (40+lbs) at WOT, you can run
a 200 shot.
Just don't run it lean(or any N20 shot) or BOOM! Instant shredding of
the air box.
I think he ran a 13.4 @ 99 on an otherwise stock 5.9, although he does
have cal tracs and bfg's for the obvious reasons.
Alan S.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:47:57 EDT