You can buy the rubber boots separately (kinda cheap IMHO) but they'll work.
Dester is right though...once some dirt gets in there, it's pretty much just
a matter of time before they go bad.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
To: dakota-truck@buffnet.net
Subject: Re: DML: CV Boots
Aren't the CV boots quite inexpensive? Since you have the whole joint out
anyways. Why not replace both of em? Saves you from having to worry about
the inner one going bad over time.
-Dester
<< Is there anyway to seal up some tiny holes in the cv boots? Will
something
like RTV work for a small time? Ther boots themselves are not cracked and
there are no large holes, but I would like to seal these holes up until I
can get them worked on/replaced. Does anyone know if I can just buy one
outer cv joint boot? Both sides of my dak has an inner as well as an outer
cv boot; I need the boot closer to the tire. I need to start looking at
replacing it 'cause it is leaking. Anyone know how much a boot will cost?
Kyle
93 Dakota 4x4 V6
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:30 EDT