Re:M1 intake; Question

From: Alan Short (ashort@flash.net)
Date: Fri Mar 10 2000 - 13:34:56 EST


"Wisotzkey, Rich" wrote:

> Alan says he had to mill the fuel rail mounts to get the injectors to seat.
> Is this necessary? My injectors are a long way from seating at the bottom
> of the bosses. They are closer to falling out, than bottoming out. They
> are seated just far enough to seal the o-rings, but that's all.
> Rich - Ashburn, VA

That's why I milled the bosses.
I wanted my injectors to fully seat and seal like they did in the factory
intake.
Alan S.



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:36 EDT