Alan,
Thanks! This really bothered me, so over the weekend I buzzed 3/16" off my
fuel rail mounts also. I feel much better now. The injectors now seet at
he bottom of the bosses. Thanks again Alan.
Rich
-----Original Message-----
From: Alan Short [mailto:ashort@flash.net]
Sent: Friday, March 10, 2000 1:35 PM
To: dakota-truck@buffnet.net
Subject: DML: Re:M1 intake; Question
"Wisotzkey, Rich" wrote:
> Alan says he had to mill the fuel rail mounts to get the injectors to
seat.
> Is this necessary? My injectors are a long way from seating at the bottom
> of the bosses. They are closer to falling out, than bottoming out. They
> are seated just far enough to seal the o-rings, but that's all.
> Rich - Ashburn, VA
That's why I milled the bosses.
I wanted my injectors to fully seat and seal like they did in the factory
intake.
Alan S.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:42 EDT