Their may have been some bolts placed in the wrong holes?? If im
not mistaken their should be three longer ones...?? Not to sure
though...Mine fit all I had to start them all then adjust then tighten but
it worked out fine...
Ken
-----Original Message-----
From: owner-dakota-truck@buffnet.net [mailto:owner-dakota-truck@buffnet.net]
On Behalf Of Dester223@aol.com
Sent: Saturday, March 18, 2000 10:23 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Thuderform Problems
The rear 3 bolts didn't line up on mine either... I guess you have to
silicone it shut, otherwise you might get moisture buildup.
-Dester
<< Did anybody that put a thunderform in their truck have difficulty putting
the
three bolts in the back of the form in???
Just got mine and the back bolts are pissing me off. It seems that they
are
too short. I have pushed on it all i can, and it will not go down
anymore.
The front two bolts went in fine and are holding the form very tight. No
movement at all. >>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:49 EDT