Robert,
Yes, the cam is degreed properly. It is dead on the spec card. No problem
there.
Rich
-----Original Message-----
From: Carboni, Robert [mailto:rcarboni@ets.org]
Sent: Wednesday, April 12, 2000 12:41 PM
To: 'dakota-truck@buffnet.net'
Subject: Subject: DML: Re: Now tight is too tight?
I have the Crower 1.7 rockers installed. While tightening the outer nut, I
turned the pushrod with my fingers until a slight resistance was felt. Then
I tightened another 3/4 turn before locking. No problems with compression
or idle, so I don't think the rockers are the problem. Was the cam degreed
correctly? Here's some real good info about proper degreeing:
http://www.cranecams.com/instructions/degreeing/degree.htm
Bob C.
'98 Durango 5.9
http://www.geocities.com/MotorCity/Track/9668/index.html#dHomeStart
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:41 EDT