wheels attn ---> KELLY in SC!! was:17" tire question

• Next message: mark janke: "overhead console computer install"
• Previous message: MLytle96@aol.com: "Re: hello"
• Next in thread: Mag318Racr@aol.com: "Re: wheels attn ---> KELLY in SC!! was:17" tire question"
• Maybe reply: Mag318Racr@aol.com: "Re: wheels attn ---> KELLY in SC!! was:17" tire question"
• Reply: Bob Mankin: "Upper control arm bushings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

hey Kelly,
could you gimme the spec on your wheels? Mainly, how wide are they and
how much backspacing and offset are you runnin'. I just saw THE wheels
I'm gonna get, now I need to figure out how deep I can set them.
thanks!

-mike d.

----->Yorktown, Va.
PROJECT 13's!! ... dumped 88 Dakota w/MAGNUM 360 swap in progress!

http://members.xoom.com/dakotaperf/index.html
miggitymike@juno.com

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk! For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

• Next message: mark janke: "overhead console computer install"
• Previous message: MLytle96@aol.com: "Re: hello"
• Next in thread: Mag318Racr@aol.com: "Re: wheels attn ---> KELLY in SC!! was:17" tire question"
• Maybe reply: Mag318Racr@aol.com: "Re: wheels attn ---> KELLY in SC!! was:17" tire question"
• Reply: Bob Mankin: "Upper control arm bushings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:11 EDT