What about the "boots" on the wires, are they going to present a problem for
me as Berndt described?
""I had originally had almost the same problem with a set of "Generic" MSD
wires. The boots for the cap are just too thick and don't hold very well.
The solution for myself was replacing the boots with some that I had from an
old kit. I now have run SplitFire and Taylor "Vertex" wires and don't have
that problem anymore.
-Bernd""
----- Original Message -----
From: Chuck Robbins <intense99dak@home.com>
To: <dakota-truck@buffnet.net>
Sent: Monday, July 17, 2000 6:16 PM
Subject: DML: Re: spark plug wires - needed ASAP
> Call up Summit Racing (800-230-3030) or Jeg's (800-345-4545)
> and have them overnight you a set of Taylor Vertex wires. These are
> 8 mm and preassembled (and they come in yellow). I don't remember
> the part number off hand, but there are others on the list that have them.
>
> Chuck Robbins
> '99 Dakota Sport
> http://www.members.home.com/clrobbins/dakota.htm
>
> > I need some assist. I ordered a set of 8.8mm accel spark plug wires for
my
> > V6. Unfortunately, not only is it a tight fit on the distributer cap,
the
> > wires tend to come loose very easily! The boots on the distributer cap
end
> > also DO NOT cover the entire connector! Anyone else had this problem??
> >
> > Unfortunately they are installed on my dak and I need a new set of wires
> > quick so I can return these! What wires do I get? I WOULD like to get
> these
> > wires in yellow - which I realize limits my options. Your help is needed
> and
> > appreciated.
> >
> > -Kevin
> > 99 V6 CC Sport S/T Solar Yellow
> >
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:52:40 EDT