They have a center disconnect system. I asked warn about it and they said
that they don't make a conversion kit for them. I own a gen II but I am sure
it is the same for the gen III's.
Chapell
-----Original Message-----
From: Chris Lang [mailto:langcj@sourcerx.com]
Sent: Tuesday, August 01, 2000 10:39 PM
To: dakota-truck@buffnet.net
Subject: DML: Re: Locking Hubs
Correct me if I'm wrong (I don't think I am though) but there are no hubs in
the Dakota 4 wheel drive system, the front axle is always turning.
Chris
----- Original Message -----
From: "Tim J Koth" <Tim.J.Koth@aexp.com>
To: "dakota-truck%buffnet.net" <dakota-truck@buffnet.net>
Sent: Tuesday, August 01, 2000 9:44 AM
Subject: DML: Locking Hubs
> This may be a stupid question to some, but does anyone know if there is
a
> locking hub kit for the front hubs on the gen3 Daks? I have a 2000 and it
> turns the whole front prop shaft and everything just running down the road
in
> 2WD. Thoughts anyone??
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:53:13 EDT