> Thanks for the info. Do these wires fit in the stock wire
> separators, or did you need to replace those as well?
>
> BTW, Kyle, I'm going to try to get to your FSM scans tonight. I
> found four pages that you'd probably be interested in. (When are you
> going to break down and buy your own service manual? :-)
Jason,
I will buy a FSM whenever I can win one off Ebay for under, ummmmm $20 :)
Geeesh!! No really.......Thanks alot, I really appreciate you doing this.
Hope things went good and Norah is feeling her best.
The MSD 8.5MM wires fit ok in the stock wire holders/separators, but I often
found 1 or 2 on each side of the engine which would pop out over time. I
think stock wires are like 7MM so maybe the added size of the MSD wires is
too large for the stock holders. Anyways, I just went to Pep Boys and bought
a set of Mr.Gasket red(to match the wires) holders/separators. They had 2-3
different kinds, meant for different wire sizes. Of course, I picked up the
set which fit the 8.5MM wires I have, and they hold the wires together very
secure, plus it makes the wires look like a much cleaner installation. These
were cheap, at a mere $5 for the set. Let me know if you have any other
questions. Thanks again!!!
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:26 EDT