I've made it easier to remove the plug heat shieds.
First use a plyiers to make the gap in them smaller -
the key is to keep them round. Then add a little
antiseize compound on the outside. This will make
them easier to remove in the future.
--- Jon Smith <jon@fast4x4.net> wrote:
> yessir, remove the wire (and not the plug) grab
> ahold with a pair of
> channel-locks and give a good twist-n-pull
> _______________________
> Jon Smith--Raleigh, NC
> jon@fast4x4.net
> www.fast4x4.net
>
> > Thanks for the advice guys. What would be the
> best way to remove those
> > round plug wire heat shields for the exhaust
> manifold? Remove plugs wires
> > and pull them out (if possible) with pliers or ???
> >
> > Thanks
> > Jay
> >
> >
> >
> >
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:42 EDT