Once you remove them, why put them back in?
- Bernd
> I've made it easier to remove the plug heat shieds.
> First use a plyiers to make the gap in them smaller -
> the key is to keep them round. Then add a little
> antiseize compound on the outside. This will make
> them easier to remove in the future.
>
> --- Jon Smith <jon@fast4x4.net> wrote:
> > yessir, remove the wire (and not the plug) grab
> > ahold with a pair of
> > channel-locks and give a good twist-n-pull
> > _______________________
> > Jon Smith--Raleigh, NC
> > jon@fast4x4.net
> > www.fast4x4.net
> >
> > > Thanks for the advice guys. What would be the
> > best way to remove those
> > > round plug wire heat shields for the exhaust
> > manifold? Remove plugs wires
> > > and pull them out (if possible) with pliers or ???
> > >
> > > Thanks
> > > Jay
> > >
> > >
> > >
> > >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:42 EDT