Re: Re: 1.7 Crower Roller Rockers

From: Terry Herrin (therrin@isaac.net)
Date: Mon Oct 23 2000 - 22:44:35 EDT

Next message: Barry Lawton: "New air hat"
Previous message: Bernd D. Ratsch: "RE: wrecked that s.o.b. =("
In reply to: TommFern@aol.com: "Re: Re: 1.7 Crower Roller Rockers"
Next in thread: mike d.: "Re: Re: 1.7 Crower Roller Rockers"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

TommFern@aol.com wrote:
> Does crower say that you must run the1.7s with guide plates? I run the 1.7s
>without them. My rpm range is up to 6000rpm. I always thought you didn't need
>to run guideplates with them.Hmm?

Crower says to run guide plates if you are run over 5500rpm. I shift
at 5200rpm so I didn't install them.

Terry Herrin
99 FR CC RT
14.769 @ 91.43
Wilmington, NC
Dakota R/T Club, Executive Board, SE Region
http://users.isaac.net/therrin/dakota.html

Next message: Barry Lawton: "New air hat"
Previous message: Bernd D. Ratsch: "RE: wrecked that s.o.b. =("
In reply to: TommFern@aol.com: "Re: Re: 1.7 Crower Roller Rockers"
Next in thread: mike d.: "Re: Re: 1.7 Crower Roller Rockers"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:56:21 EDT