ABeerCan@aol.com wrote:
> Ok, here is the low down. We started with a Magnum 360 block, opened the
<large snip>
Will,
Sounds like a potent mill for sure. This is similiar to the build-up
that
I've been planning. I do have a few questions tho - since the magnum
heads get
oil from the pushrods and the LA heads get it from the lifter galley
area (thru
the block) - how are you oiling those Edelbrock (LA) heads? Also, if
you are
using Edelbrocks LA heads, how are you utilizing the magnums beer barrel
intake
considering the bolt holes in the magnum intake are straight up/down and
the LA
heads are at an angle??
I'm currently on a project in Tupelo, MS which is only about a half
hour from
Starkville. I myself graduated from Miss. State Univ. and miss that
atmosphere
alot 8-). I miss Cheers, The Landing, Dougs, Mulligans, and the other
clubs but
definately not the HOT BEER!!
Latr,
Shane
ps - maybe we could hook up and do some bench racing.... free steak
dinner on my
expense account 8-)
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:45 EDT