just one question Bernd... where's mine??? :-) keep us posted man! I'm
gonna need one w/ my next cam :)
______________________
Jon Smith--Raleigh, NC
www.fast4x4.net
jon@fast4x4.net
ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
-
-Well, here goes:
-
-Bruce Bridges: Has the box - No reports...yet.
-
-Tim Berry: Has the box and installed - Preliminary report...Had to readjust
-the FMU to an 8:1 plate (from a 12:1...running too rich under boost). Also
-improved his shift points...don't know if this is an after effect or just a
-coincidence. Runs much stronger.
-
-William: Has the box and installed - Preliminary report...MSD BTM turned
-back down to 1 (was at 2.5).
-Runs much stronger.
-
-Richard Pyburn: Box has been shipped - Waiting for delivery and
-installation.
-
-Myself: Installed Revision 2.0 of the box (two piece instead of one piece)
-and removed the MAP check valve. 50mm TB now has no problems at all with
-part throttle "stumble" and will be installing the 10:1 plate (removing the
-12:1...running a bit rich under boost). Very strong on part throttle
-acceleration now.
-
-The IAT adjustment has been set to a range of 16 - 190 degrees (no need to
-go below 10...there's no change in timing or fuel delivery) and the
-adjustments can all be changed from 1v - 4v.
-
-I'll be posting again in about a week from now with more results
-on the box.
-So far...it's looking REALLY promising! :)
-
-- Bernd
-
-
-
-
-
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:44 EDT