I just used the same permatex anti-sieze that I used on the plug threads...
> In a message dated 3/15/01 9:09:59 PM Eastern Standard Time,
> silva@rio.bravo.net writes:
>
> << What is the stuff that is supposed to ease installation and
> extraction of
> > > plugs from the aluminum heads? >>
>
> It's called dielectric grease. You'll want to apply a small
> amount to each
> coil-on-plug just inside the boot and to "O" ring. Don't goop it
> on. Just a
> little. Heat will cause the rubber to bond with the spark plug if
> you don't
> use it. Then, next time you try to change the plugs, the
> coil-on-plug could
> break, and you will cry when you find out how much it costs to
> replace them.
>
> Paul
> 00 CC 4x4 Supercharged 4.7
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:12 EDT