Greasy,
The bosses themselves do not need milled. It is the standoffs for the fuel
rails that need cut down. The stock height on some did not allow the
injectors to seat into the bosses properly. I had to remove 3/16" from my
standoffs to get the injectors to seat into the throat of the bosses.
Rich - Ashburn, VA
-----Original Message-----
From: greasy [mailto:gg428@hotmail.com]
Sent: Wednesday, March 21, 2001 2:00 PM
To: dakota-truck@buffnet.net
Subject: DML: MPI intsall question
I know that several of you have done the mpi install and had problems with
leaking injectors...
I remember talk of milling the bosses on some manifolds, anybody who did
this, how much was milled, and any other info would help.
thanks.
greasy
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:19 EDT