Doug,
What were the aftermarket plugwires you replaced the originals with?
Just curious.
Thanks
Jay
-----Original Message-----
From: Doug Fedeli <rdf@eznet.net>
To: dakota-truck-moderator@bent.twistedbits.net
<dakota-truck-moderator@bent.twistedbits.net>
Date: Saturday, March 24, 2001 12:20 PM
Subject: DML: MSD superconductors installed
>I just finished putting the MSD wires on my V6 Dak. I got the V6 set
>since I had a gift certificate from Christmas to Auto Zone that would
>cover most of the cost of the wires. When I was swapping the wires I
>measured the resistance of the old wires and the MSDs. The old wires
>were about 1600 ohms to about 2600 ohms and about 3200 ohms for the coil
>wire. The MSDs are 52 ohms to 103 ohms. The coil wire is 160 ohms. When
>measuring them I found the wire I used for the #4 plug is 18k ohms. I
>sent an e-mail to MSD about this and I'll let you know what they say.
>The old wires were aftermarket replacements I bought a couple of years
>ago. They're alittle better than stock. (but not much) The MSDs are all
>40 ohms/ft or less. the old ones are over 1000 ohms/ft. The truck idles
>even smoother than before. I can't wait to see how is runs after I get a
>good wire on the #4 plug.
>
>Doug Fedeli
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:25 EDT