Try it at .045", just watch the engine performance under a load and at
higher rpm's. If it misses or lacks some power ont he top end, you'll
either have to replace the factory coil with a more performance oriented on
or put the gap back to .040".
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
Sent: Friday, March 23, 2001 10:09 PM
To: dakota-truck@buffnet.net
Subject: DML: Re: RE: Re: RE: Installed the MSD
i wuz thinkin the same thing bernd...maybe .045 if at all
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@buffnet.net>
Sent: Saturday, March 24, 2001 5:28 PM
Subject: DML: RE: Re: RE: Installed the MSD
> I'd stick witht he stock gap with the factory coil.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> Sent: Friday, March 23, 2001 3:35 PM
> To: dakota-truck@buffnet.net
> Subject: DML: Re: RE: Installed the MSD
>
>
> Thanks bernd. will i need to increase the gap at all? since it is a stock
> coil?
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@buffnet.net>
> Sent: Saturday, March 24, 2001 3:05 PM
> Subject: DML: RE: Installed the MSD
>
>
> > Give it a little bit, but the "zing" should be there...a little bit.
Try
> to
> > notice the idle quality, acceleration (smoother or not?) and MPG in the
> long
> > term.
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> > Sent: Friday, March 23, 2001 2:53 PM
> > To: DML
> > Subject: DML: Installed the MSD
> >
> >
> > Well i put the MSD in , wired the factory coil into it.
> >
> > Ok, now where is the ziiing at? It ran pretty much like normal, no Check
> > engine light or anything yet. Too early to tell yet?
> > Any other MSD stories or advice?
> > I put in the 6A box.
> >
> > Paul
> >
> >
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:26 EDT