thanks bernd, i guess it's time to end this string.
thanks fer yall's help
Paul
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@buffnet.net>
Sent: Sunday, March 25, 2001 7:44 AM
Subject: DML: RE: Re: RE: Re: RE: Installed the MSD
>
> Try it at .045", just watch the engine performance under a load and at
> higher rpm's. If it misses or lacks some power ont he top end, you'll
> either have to replace the factory coil with a more performance oriented
on
> or put the gap back to .040".
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> Sent: Friday, March 23, 2001 10:09 PM
> To: dakota-truck@buffnet.net
> Subject: DML: Re: RE: Re: RE: Installed the MSD
>
>
> i wuz thinkin the same thing bernd...maybe .045 if at all
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@buffnet.net>
> Sent: Saturday, March 24, 2001 5:28 PM
> Subject: DML: RE: Re: RE: Installed the MSD
>
>
> > I'd stick witht he stock gap with the factory coil.
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> > Sent: Friday, March 23, 2001 3:35 PM
> > To: dakota-truck@buffnet.net
> > Subject: DML: Re: RE: Installed the MSD
> >
> >
> > Thanks bernd. will i need to increase the gap at all? since it is a
stock
> > coil?
> > ----- Original Message -----
> > From: "Bernd D. Ratsch" <bernd@texas.net>
> > To: <dakota-truck@buffnet.net>
> > Sent: Saturday, March 24, 2001 3:05 PM
> > Subject: DML: RE: Installed the MSD
> >
> >
> > > Give it a little bit, but the "zing" should be there...a little bit.
> Try
> > to
> > > notice the idle quality, acceleration (smoother or not?) and MPG in
the
> > long
> > > term.
> > >
> > > - Bernd
> > >
> > > -----Original Message-----
> > > From: owner-dakota-truck@buffnet.net
> > > [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> > > Sent: Friday, March 23, 2001 2:53 PM
> > > To: DML
> > > Subject: DML: Installed the MSD
> > >
> > >
> > > Well i put the MSD in , wired the factory coil into it.
> > >
> > > Ok, now where is the ziiing at? It ran pretty much like normal, no
Check
> > > engine light or anything yet. Too early to tell yet?
> > > Any other MSD stories or advice?
> > > I put in the 6A box.
> > >
> > > Paul
> > >
> > >
> >
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:26 EDT