Should be 1/4" NPT.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Kyle Kozubal
Sent: Tuesday, March 27, 2001 8:08 AM
To: dakota-truck@buffnet.net
Subject: DML: Re: Relocated my AIT sensor !!
> After all the discussion about the AIT , I finally broke down and
relocated it. Its now in the "open air" right at the back of the hood where
it meets the cowl.
> I plugged the intake with a pipe plug.
> Its been VERY cold here the past few days, so it was getting some pretty
cool air. I took it for a test run, all I can say is WOW !!! what a
difference!!
> That has to be close to the best mod I have done!!
> I'm a little concerned about the effect on my MPG, but man what a kick in
the pants!!
Any idea on the pipe plug specs? Would all engines use the same tread/pitch
etc for this plug? Was the length of the wires/connector long enough to
effectively relocate it far away? Or did you have to splice in some longer
wires? I am now want to relocate the IAT this weekend, and just see how the
relocation works before/if I get a Bernd IAT box. Thanks.
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:29 EDT