318 (5.2L) Stroker

From: KenneallyIII@Gateway.net
Date: Fri May 11 2001 - 23:30:46 EDT


I've been checking out the Hughes engine site.
Has anyone out there tried building a stroked Magnum 318 using the 340 4" stroker crank?
Custom pistons would definately be necessary; but can the crank be fitted into the block?
How about the rear main seal situation?
I've got a second 318 Mag. to play with, and 390 ci or so sounds pretty good.
Also, has anyone retrofitted a KenneBell S/C into a Pre-'94 Dakota?
The folks at KB have been less than helpful when I've brought up the subject of my '93.
--------------------------------------------------------------------------------
         (__) ,---------. NOTE: The preceding message was sent via Jaek and
         (oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to say, the
  /-------\/_/ : :: :: : ) person who sent this message could in fact be an
 / | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this message was
* ||"" || \__________/ mailed to you from the cs.fredonia.edu domain, it
   ^^ ^^ could have been generated by anyone in the world.
Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon- (stei0302)
--------------------------------------------------------------------------------



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:28 EDT