The lid of my K&N sitting on top of my M1 has a nice little indentation in
my hoodliner. A little close? I also cut about 1/2" off the "S" bolt. It
had previously cut an inch wide slot through the hoodliner. That's a little
to close to pulling a "RT" if you ask me.
Rich - Ashburn, VA
-----Original Message-----
From: jon@dakota-truck.net [mailto:jon@dakota-truck.net]
Sent: Tuesday, June 05, 2001 11:37 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: Re: DML: Re: M1 2BBL Intake Pics
Jon Smith <jon@fast4x4.net> wrote:
: I thought the same thing (height) but w/ the 2bbl adaptor on the MPI, is
it
: any taller? The MPI w/ adaptor is right at stock manifold height, if it
: were any taller I would imagine there would be fitment problems... aka
hood
: interference...
Yep, I immagine they engineered it to be more or less the stock height,
since they went through the trouble of building one at all... Just as
an aside, the MPI's height is very close to stock, but its 1/8" to 1/4"
higher. No problem for most trucks, but if you've got a tall air
cleaner, ram-air system or something, it could be...
---Jon-
.---- Jon Steiger ------- jon@dakota-truck.net or jon@jonsteiger.com -----. | Affiliations: AOPA, DoD, EAA, NMA, NRA, SPA, USUA; Rec & UL Pilot - SEL | | '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96 FireFly 447 | `------------------------------------------ http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:45 EDT