I'll dig them up...went through this with the IAT Adjuster...that's why
there are no "Dodge-Like" connectors with them.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net] On Behalf Of Wisotzkey, Rich
Sent: Thursday, June 07, 2001 8:20 AM
To: 'dakota-truck@buffnet.net'
Subject: DML: RE: RE: RE: Re: Automotive Connector Sources
Bernd,
Oh, they did a real good job of making the connectors on my truck
non-descript. There are no markings of any kind on my MAP wiring
harness connector. It doesn't even have pin numbers on it. The MAP
sensor itself does at least have a couple numbers on the bottom of it.
I need to look at these a little closer. If anyone has a part number on
their MAP connector, I'd appreciate knowing what it is. Rich
-----Original Message-----
From: Bernd D. Ratsch [mailto:bernd@texas.net]
Sent: Thursday, June 07, 2001 8:38 AM
To: dakota-truck@buffnet.net
Subject: DML: RE: RE: Re: Automotive Connector Sources
The MAP (and IAT sensor) connector are both from AMP. Look at the small
number on the actual connector and contact AMP direct for a
cross-reference.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net] On Behalf Of Wisotzkey, Rich
Subject: DML: RE: Re: Automotive Connector Sources
Thanks Kyle,
I went off surfing for connectors and found nothing. Even broke down
and called the dealership to see if they could tell me who manufactured
them. "Duh!" Needless to say that was worthless. I'll check out
Pep-Boys and see what they have. I'm trying to find the exact same
connectors that the MAP sensor uses. This will make installing my "MAP
Adjuster" a piece of cake. Rich
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:46 EDT